Alliance-laundry-systems H2641 Manuel d'utilisateur télécharger pdf (Page 20)

Installation

800536

Water Supply Requirements

NOTE: Water supply faucets must fit standard

3/4 inch (19.1 mm) female garden hose couplings.

DO NOT USE SLIP-ON OR CLAMP-ON

CONNECTIONS.

NOTE: Water supply faucets should be readily

accessible to permit turning them off when washer

is not being used.

Water Temperature

Cold:

Recommended cold water temperature is 60° to

80° Fahrenheit (16° to 27° Celsius).

Hot:

Recommended hot water temperature is 120° to

140° Fahrenheit (49° to 60° Celsius).

Warm:

Mixture of hot and cold water. (Warm water

temperature is dependent upon the water temperature

and the pressure of both the hot and cold water supply

lines.)

IMPORTANT: Turn off water supply faucets after

check-out and demonstration. Owner should turn

off water supply whenever there will be an

extended period of non-use.

NOTE: Longer inlet hoses are available (as

optional equipment at extra cost) if the hoses

supplied with the washer are not long enough for

the installation. Order hoses as follows:

No. 20617 Inlet Hose (8 feet) (2.44 m)

No. 20618 Inlet Hose (10 feet) (3.05 m)

Figure 14

Water Pressure

Pressure must be a minimum of 20 to a maximum of

120 pounds per square inch (138 to 827 kPa) static

pressure measured at the faucet.

NOTE: Water pressure under 20 pounds per

square inch (138 kPa) will cause an extended fill

time in the washer and may not properly flush out

the detergent dispenser.

Under certain conditions, hydrogen gas

may be produced in a hot water system

that has not been used for two weeks or

more. HYDROGEN GAS IS EXPLOSIVE. If

the hot water system has not been used

for such a period and before using the

washer, turn on all hot water faucets and

let the water flow from each for several

minutes. This will release any

accumulated hydrogen gas. The gas is

flammable. Do not smoke or use an open

flame during this time.

W029

WARNING

H137I

1 Water Supply Faucets

2 Hot Water Connection

3 Cold Water Connection

4 Water Inlet Hoses

H137I

WATER

MIXING

VALVE

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 69 70

Commentaires sur ces manuels

Pas de commentaire

Alliance-laundry-systems H2641 Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Rondelles Alliance-laundry-systems H2641