Alliance Laundry Systems CP100PHN2 Manuel d'installation télécharger pdf (Page 35)

Programming

F8112301

Copy Mode

In order to access Copy Mode, ensure “StArt” is on

display and turn programming key to Prog. Very

quickly press “Enter 328” on keypad. If “Prog 08”

appears, keys were not pressed quickly enough. Press

Stop to abort and start over. If “CoPY PrG” appears

on display, Copy Mode is activated.

NOTE: If programming key is not turned to Prog

when this is attempted, “A0” will appear on display

indicating Copy Mode has been locked out.

Table 7

Example: To copy program 41 to program 5, do the

following. Enter Copy Mode as explained above.

Source.00: Enter source program number (41) on

keypad.

Source.41: Press Enter.

Dest .00: Enter destination program number (05) on

keypad.

Dest .05: Press Enter.

41....05: Press Enter to confirm operation.

Start: The display will return to “StArt” prompt. The

program has been copied.

PS40 Diagnostics

Alarm Codes

Alarm codes are used to alert operator to problems

with machine’s performance. However, because

alarms do not indicate safety problems, they do not

interrupt operation of machine. When an alarm occurs,

control will flash code on Program Number/Alarm

display (refer to Figure 2) to get operator’s attention.

Operator should make note of this code and report it to

a technician so issue can be resolved. Note that all

alarm codes are composed of the letter “A” followed

by a code reference number.

Table 8

Copy Prg

Press

Enter.

Source.00

Enter two-digit source program number –

this is the program number to make a copy

of. Press Enter.

Dest .00

Enter two digit destination program number

– this is the program number to store copy

in. Press Enter.

01....02

The PS40 will display “source . . . .

destination” program numbers to confirm

operation. Press Enter to complete operation

or Stop to abort operation.

Code Description

Program key was in wrong position when trying to

access Programming Mode. Press Enter to clear.

Program selected does not exist. Press Enter to

clear.

Machine has not been setup (pre-program) or

memory has been lost. Refer to Start Up section.

Press Enter to clear.

Programmed water level was not achieved within

15 minutes. Press Enter to clear.

Programmed temperature for supplemental heating

was not achieved within 60 minutes. Press Enter to

clear.

Temperature in cylinder is unsafe at end of a

program (greater than 150°F [65°C]). Wait until

load cools to prevent burns. Press Enter to clear.

There is water remaining in machine at end of

program. Press Enter to clear.

Temperature sensor is not working properly. Press

Enter to clear.

Rear enclosure temperature too high. Clean

cooling fan filter. Press Enter to clear.

There is already water in the machine when a

program was started (check for leaking water

valves). Press Enter to clear.

There was water remaining in machine after 3

minutes of draining (check for clogged drain).

Press Enter to clear.

Machine is not running at correct speed or speed

sensor is damaged. Press Enter to clear.

NOTE: Anything that stops analog voltage or

directional voltage could cause alarm (i.e. loose

door switch connections).

Final extract was at a lower speed than

programmed (fixed mount machines only). Load

could not be balanced for a fixed speed spin.

Final extract was skipped (free standing machines

only).

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 58 59

Commentaires sur ces manuels

Pas de commentaire

Alliance Laundry Systems CP100PHN2 Manuel d'installation Page 35

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à laver Alliance Laundry Systems CP100PHN2