Alliance Laundry Systems HCN040HNV Spécifications télécharger pdf (Page 44)

NOTE: If installing a 20 through 60 pound model di-

rectly to finished floor, wait until grout is completely

cured and skip to Step 18. If installing on elevated

base frame, proceed to Step 14.

20-60 Pound Models

14. After the grout is completely cured, position the machine over

the elevated base frame.

15. Align the mounting holes on the machine with the corre-

sponding holes on the elevated base frame.

16. Install a bolt, flat washer and locknut in each mounting hole.

17. Hand tighten each nut.

a. Tighten the two rear nuts two turns.

b. Tighten the two front nuts two turns.

c. Tighten the two middle nuts firmly.

18. Torque all the locknuts to 90 ± 9 ft.-lbs. – one after the other

– until all are tightened evenly and the machine is fastened se-

curely to the elevated base frame or floor.

80 Pound and Larger Models

19. After the grout is completely cured, torque the locknuts to 150

± 15 ft.-lbs. – one after the other – until all are tightened even-

ly and the machine is fastened securely to the floor.

IMPORTANT: Refer to recommended grout cure

times from manufacturer before torquing locknuts.

NOTE: Check and retighten the locknuts after five to

ten days of operation and every month thereafter.

PHM811N_SVG

Acrylic Adhesive Anchors [refer to Table 20 ]

1. Machine Frame Base

2. Grout 0.5 in. [13 mm]

3. Acrylic Adhesive

4. Anchor Bolt [minimum Grade 5 SAE rating]

5. Concrete

6. Drill Hole Size per Manufacturer Requirements

7. Edge of Pad

Figure 21

Installation

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 76 77

Pas de commentaire

Alliance Laundry Systems HCN040HNV Spécifications Page 44